RO-45 model - Vibration/Noise
Noise can be sporadic and periodic as a result of a sudden surge in water pressure in your household. If it occurs, don't be too over-anxious to pinpoint the cause. Observe and give it a few days before you pinpoint the exact cause.
Problem | Causes | Identify | Solution | ||
1 | Humming/Buzzing Noise | 1. Air trapped in check valve | See Figure 2, Point E | 1. Flush out the Air Bubbles, after a few minutes the sound should subside 3. Foaming around the RO system | |
2 | Sputtering/Jack Hammer Noise | 1. Defective ASO (Very Rare) 2. Forgot to insert membrane 3. Membrane inserted wrongly | 1. Water in ASO can't flow smoothly See Figure 2, Point C 2. Empty membrane housing 3. Membrane inserted Wrongly | ||
3 | Severe Vibration | Wrong Line Installation | See
diagram and point identification | Rectify it | |
4 | Noise from drain | 1. Location of drain saddle 2. Inherent 3. Restriction in Drain Line | 1. Set the drain saddle on the drain pipeas low as possible. See Figure B, point W. 2. None 3. Clean the drain line |